For dental lab
work, nothing beats the quality of WILOFA diamond instruments. Profit
from our experience and work with precise tools.
- for shaping of fuse-on ceramic
- for separation after rough fuse-on
- for drilling of oxide-ceramic frameworks
- for touching up the fissures in ceramic
- for precise drilling of
silicate-ceramics, inlays, veneers, partial crowns and crowns
Diamond instruments with 80-120 micron grit for
- profile/form corrections on fixation
parts of chrome cobalt prostheses
- profile/form drilling of casting parts of
Special care during the finishing process
of ceramic frameworks and facings with WILOFA® Technica
WILOFA® Technica Diamond Instruments
have proved very worthwhile in the finishing process of ceramic
materials, in edgework of sintered, full-ceramic crowns and bridges, in
the shaping of connectors, in the removal of edge reinforcements and
surface disturbances, in working with fuse-on ceramic on PFD or full
ceramics - in fine-grit quality for polishing surfaces.
A special coating with hard diamond grit
gives our instruments their high grinding power, especially on
sintered-oxide ceramics (aluminum-oxide, zirconium-oxide) and
fluorapatit fuse-on ceramic. Only minimum manual power is
required, thus avoiding micro-fissures in the ceramic structure.
WILOFA® Technica Diamonds
bring facings into form.
Technica Diamond Instruments
" Ceramic steel " requires special
Blockbuster: WILOFA® Technica Diamonds for oxide-ceramics
Cercon, Cerec YZ, DC zircon, Digizon,
Everest ZH/ZS, lava, VITA YZ - all systems offer full-ceramic materials
for crown caps and bridge frameworks made out of zirconium-oxide (ZrO2)
with more than 1000 megapascal final firmness. Known as "ceramic steel"
with 10 metric tons of loading capacity per cm², they are
nevertheless a challenge for the dental technician. Fine, corrective
grinding of inner-lumens of crowns and connectors, while paying
attention to the model - this requires high-performance diamond
grinders in the spray-cooled laboratory turbine which prevent
overheating and micro-fissures from permanently damaging the ceramic
framework. And yet, quick ceramic removal with minimal manual power is
WILOFA® Technica Diamonds dispose of a
special coating with hard diamond grit especially applicable for
work on zirconium-oxide and aluminum-oxide ceramic frameworks, also in
the final-sintered state. To avoid overheating we recommend "wet
grinding" with this special grit coating, which has been developed
especially for the finishing process.
WILOFA® Technica Diamonds are also
suitable for materials like precious metals, non-precious alloys,
chrome cobalt and PVC, model materials.
If you would like to find out more about
our diamond instruments, don't hesitate to call us. We would be glad to
answer any questions.